The samophlange control console can be used to automatically regulate the flow of fuels, gasses, liquids, and related machinery. Once initial configuration has been completed, it should run worry free with minor maintenance.
Brief listing of control console components (from left to right)I. Main Power Lever
The engaged position enables the samophlange. The control mechanism will not automatically disengage when the lever is put in the off position. This will merely
begin the cooldown process, at which point it will take roughly one to two minutes (depending on the situation) to turn off.
IMPORTANT NOTE: The main power lever can only be manipulated when the three control valves on the actual machinery have been disengaged. These valves can be shut off in any order.
The first is the MAIN CONTROL VALVE, which can be found at the base of the large, vertical smokestack. Next, the FUEL CONTROL VALVE can be found on the large pipe which leads
from the fuel tanks (there should be three of them) to the smokestack. Finally, the REGULATOR VALVE can be found on the lower of the two large, cylindrical tanks that flow into the smokestack.
II. Fuel Gauges
Displays the current pressure in the primary, secondary, and tertiary fuel tanks.
III. Flow Gauge
Displays the current rate of flow within the system.
IV. Flow Controls
Increase or decrease the flow rates. This is automatically controlled by the samophlange control mechanism.
V. Temperature Gauge
Displays the operating temperature of the system in general.